A new protocol for Land Rover vehicles is now available on Flex : with this latest software update, you will be able to program MD1CP007 engine units in Bench mode.
Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start working: you will optimize performances of vehicles such as Defender and Range Rover or remove trouble codes from Bosch MD1CP007 .
Please note: Flex V1 will soon be disabled.
Download the setup of Flex V2 latest version here and install the new interface in a few simple steps*
*If your subscription is temporarily inactive, you can still use Flex V2. However, the Datalogger feature as well as protocols released after the expiration of your subscription will not be available.
Some of the supported vehicles:
This new protocol is available for the following software packages:
Newly added protocols:
Reading Time: ~ 1 minutes and 30 seconds Writing Time: ~ 1 minutes
Software Improvements :